Close or Esc Key

Arduino Projects   |   Raspberry Pi   |   Electronic Circuits   |   AVR   |   PIC   |   8051   |   Electronic Projects

Arduino Based AC Voltage Control using Zero Voltage Crossing Detection



A very good site for learning electronics


Nice explanation But a small and major mistake found in code, 

attachInterrupt(0, acon, FALLING);

correct it to

attachInterrupt(2, acon, FALLING);

My project is based on Parallel feeder protection fed from both side.

Here i have to use antiparallel thyristor to remove faulty part whem fault occurs. So i have to design the Gate control circuit of Thyristor so that it opens when over current  occurs.

So if you have any idea about it the please help me.

Thank you