Close or Esc Key

Arduino Projects   |   Raspberry Pi   |   Electronic Circuits   |   AVR   |   PIC   |   8051   |   Electronic Projects

Interfacing AT24c64 with 89c52 problem while reading & writing

6 posts / 0 new
Last post
Jenifer
Jenifer's picture
Offline
Last seen: 3 years 5 months ago
Joined: 24/07/2013 - 16:13
Interfacing AT24c64 with 89c52 problem while reading & writing

Hai.....

 

     while reading the eeprom it shows some garbage values.can anyone please tell me why is it so?

AJISH ALFRED
AJISH ALFRED's picture
Offline
Last seen: 2 years 10 months ago
Joined: 10/01/2012 - 12:10
Hi Jenifer,So many things

Hi Jenifer,

So many things could go wrong, like in your hardware make sure that you have connected the SDA and SCK lines to VCC through a resistor. Check you have connected the address pins A0, A1 of the EEPROM. 

In your code make sure that you are using the same address to access the EEPROM. 

Jenifer
Jenifer's picture
Offline
Last seen: 3 years 5 months ago
Joined: 24/07/2013 - 16:13
Dear sir,           I am

Dear sir,

           I am using AT24c64 and AT89c52. the resistor value am using is 22k. Is that enough or i have to make some alterations in resistor value? if it so means please tell me the resistor value......  

 

Thanks in advance....

Jenifer
Jenifer's picture
Offline
Last seen: 3 years 5 months ago
Joined: 24/07/2013 - 16:13
Dear sir,          My problem

Dear sir,

 

         My problem is, i had stored some values in eeprom. while reading the stored values it shows some values which i was not stored in e2prom. can u please tell me where is the problem is and what alterations i have to do, to clear this bug.

 

Thanks in advance........

Ashutosh Bhatt
Ashutosh Bhatt's picture
Offline
Last seen: 1 week 5 days ago
Joined: 21/12/2010 - 15:59
pls post here problems,

pls post here problems, doubts, queries only