Arduino Projects   |   Raspberry Pi   |   Electronic Circuits   |   AVR   |   PIC   |   8051   |   Electronic Projects

program atmel 8051 via can bus protoco&flip software

1 post / 0 new
abolfazl
abolfazl's picture
Offline
Last seen: 1 week 6 hours ago
Joined: 28/07/2019 - 19:49
program atmel 8051 via can bus protoco&flip software

hi

i see forum 8051 and not  Enough information on this topic so i I decided to make this thread.

plz share your information together.Here are some basic questions to discuss

1-in ic at89c51cc03 that have control can bus how should program via can node this ic.

2-software flip support several interface usb to can bus that can connect to conector node can board and program atmel

so when connect interface why have time out in software flip.

i take atmel in flip mode:pin EN=0 pin PESN=1.if should do anything before connect interface to can node.

3-if interface usb to can convert usb to can bus or make one port can on pc.

Log in or register to post comments